Start-up and Operation
3. Lift the cover and disengage the cable drum drive pin by pulling the pin out (see figure 11a). Turn the pin so that the pin is
locked in the disengaged position. The cable drum should now turn freely. Close the cover.
Figure 11a. Drive Pin Disengaged. Figure 11b. Drive Pin Engaged.
4. Carefully pull the cable out to the cable anchor. The cable is 360 feet long so the cable anchor should be less than 360 feet
from the RainTrain2
®
. Note: If you use less than the full 360 feet of cable, make sure the remaining coils of cable are tight on the
cable drum. Secure the cable end to the cable anchor so that the cable is held as close to the ground as possible (see figure 11c).
In light sandy soils it may be necessary to replace the standard anchor with a larger anchor.
5. Lift the cover and re-engage the cable drum drive pin to the cable drum (see figure 11b). Check for loose cable coils and tighten
if necessary. Close the cover.
16
Summary of Contents for RainTrain2
Page 1: ......
