background image

Nelson Irrigation Corp.   848 Airport Rd.   Walla Walla, WA  99362-2271 USA   Tel: 509.525.7660    Fax: 509.525.7907   E-mail: [email protected]   Web site: www.nelsonirrigation.com

 

MR/MRDC 

MDC Guide

TYPICAL APPLICATIONS

4

  

 

4.0 TYPICAL APPLICATIONS

4.1  ROTATOR ORCHARD SPRINKLER. 

Orchards are commonly planted on 
sloping terrain. The MR and MRDC are 
useful to deliver equal water top and 
bottom. The MRDC is additionally useful 
to keep the water in the pipe from draining 
to the low area to reduce wet spots in the 
low end of the field.  The MDC is useful 
where pressure regulation is not required 
but holding the pipes full of water is 
necessary.

4.2   OVERTREE COOLING 

The spray of water over apples and other orchard crops is a common practice that can prevent damage 
due to heat and sunburn. The check feature of MRDC and the MDC prevents drainage of the system pipes 
in-between frequent on-and-off cycles of the cooling irrigation system. The result is more efficient on-off 
cooling cycles.  Growers like the quick start-up of the sprinklers to rapidly wet the fruit.

4.3   DRIP LINES 

The low pressure operation of drip lines requires exact pressure control. Slight variations caused by pump 
pressure or elevation can cause undesirable irrigation uniformity. The MR is very useful in controlling the 
pressure on the drip line. The MRDC and MDC are useful in keeping the submains full of water.

4.4   ROTATOR FOR WHEEL LINES 

The adequate pressure on Rotator sprinklers is essential for uniform irrigation. Wheel lines are commonly 
put on undulating land. The pressure can also vary as adjacent wheel lines are turned on and off. In this 
condition, the regulator will keep the flow rate the same from each sprinkler (it is essential the minimum 
pressure is available).

Save power and water by being accurate in the amount of water out of each device. Caution: The drain-
check feature of the MRDC or MDC is not good for wheel lines because the pipes must be empty in order 
to move the wheel lines. Use only the MR on wheel lines because pipe drainage is needed.
 

4.5 GREEN HOUSE IRRIGATION 

The drain check will keep the sprinklers from dripping or draining after shut off and quick start-up. 

Same flow top  

to bottom

Summary of Contents for MR









Reviews: