Nellcor Oxinet III, Service Manual

Page: 21 / 62

Service Manual Installation
Oxinet III 15
Wireless Configuration
Connect the Oximeter to the Transmitter
The following Nellcor oximeters are supported in the Oxinet III system:
• N-395
• N-550
• N-595
• N-560
• N-600
The oximeter data output port must be configured as follows:
• communication protocol — ASCII
• baud rate — 9600
Refer to the Oximeter’service manual for details on Oximeter settings.
1
Place the Transmitter (Client Bridge) near or on top of the Oximeter (Figure 4).
2
Connect the Oximeter to the Transmitter using the transmitter’s RS-232 cable
(Figure 4).
3
Connect one end of the AC Y-cord to each unit (Oximeter and Transmitter) and
plug the other end into the AC outlet (Figure 4).
Connect the Access Point to the Router/Switch
1
Install a Cat5 cable from the RJ45 jack on the back of the Access Point to any of
the numbered RJ-45 LAN ports on the back of the Router/Switch (Figure 4).
2
Connect the Access Point Antenna to the Primary Antenna Connector on the back
of the Access Point (Figure 4).
3
Connect DC barrel connector end of the DC Adapter Power cable to the round DC
jack on the back of the Router/Switch and plug the AC plug end into an AC outlet
(Figure 4).
4
Connect DC power to the Access Point by performing either the
Single Access
Point Power Supply Connection
procedure or the
Multiple Access Points
Distributed Power Supply Connection
procedure.
a. Single Access Point Power Supply Connection
— This option can be used
if a single Access Point is to be installed in a location (such as a bookcase or
tall shelf) where an AC power outlet is available.
• Plug the DC barrel connector end of the DC Adapter Power cable into
the round power jack on the access point and plug the AC power cord
into an AC outlet (Figure 4).