13
11.2.
Sound diagnostics in case of anomaly
1 Beep
The lock is set in "with actuator" mode but does not receive any
commands from the actuator.
- The lock does not move because it didn't receive the command.
- Check the contact of wire "3" of the lock and that dip-switch No. 2 of the
actuator is on ON.
4 Beeps The actuator (or actuators) are in error.
- The lock is ready for the command but the connected actuators are in error.
- Check the diagnostics of the actuators connected to the electromechanical
lock.
12. Checking for correct assembly
Check that the window is perfectly closed at corners and that there are no
obstacles caused by incorrect positioning during assembly.
Check that when the window frame is closed the chain terminal is at least a
few millimetres away from the actuator body. This will ensure the window is
properly closed and seals are correctly compressed. In the event that this
should not be the case there is no guarantee that the window is closed
correctly.
Check that hinges and support brackets are aligned to each other and tightly
fixed against the window frame with screws fixed correctly into position.
Check that the window reaches the desired position according to the stroke-
end selected.
13. Emergency manoeuvres, maintenance or cleaning
In the event that the window frame should require manual opening due to power
failure or problem with the mechanism or for normal maintenance or external cleaning
of the window frame, in built-in actuators it’s necessary to perform these operations:
1. Unscrew the two screws that fix the sash to the attachment bracket.
2. Take care during this operation since the bracket, which is in two pieces after
removing the screws, may fall as it is no longer secured.
3. Manually open the window frame.
A
TTENTION
:
DANGER
– the window could fall as the sash is no longer
held in position by the chain.
4. After maintenance and/or cleaning repeat points 1 and 2 in reverse order.
14. Troubleshooting
Possible causes of malfunction during installation or use.
14
Problem
Possible cause
Solution
Actuator does not work
No electricity at feeder
Check status of circuit
breaker or safety switch
Cable not connected or
wire disconnected.
Check electrical
connections at reduction
motor
15. Environmental protection
All materials used in the manufacture of this appliance are recyclable.
We recommend that the device itself, and any accessories, packaging,
etc. be sent to a centre for ecological recycling as established from laws
in force on recycling. The device is mainly made from the following
materials: aluminium, zinc, iron, plastic of various type, cuprum. Dispose
materials in conformity with local regulations about removal.
16. Certificate of guarantee
The manufacturer will guarantee good function of the appliance. The
manufacturer shall undertake to replace defective parts due to poor
quality materials or manufacturing defects in accordance with article 1490
of the Civil Code.
The guarantee covers products and individual parts for
2 years
from the
date of purchase. The latter is valid as long as the purchaser possesses
proof of purchase and completion of all agreed conditions of payment.
Guarantee of good function of appliances agreed by the manufacturer
implies that the latter undertakes to repair or replace free of charge and in
the shortest period possible any parts that break while under warranty.
The purchaser is not entitled to any reimbursement for eventual direct or
indirect damage or other expenses incurred. Attempt to repair by
personnel unauthorised by the manufacture shall render the warranty null
and invalid.
The warranty does not cover fragile parts or parts subject to natural wear
and tear or corrosion, overload, however temporary etc. The
manufacturer will accept no responsibility for eventual damage incurred
by erroneous assembly, manoeuvre or insertion, excessive stress or
inexpert use.
Repairs performed under guarantee are always "
ex factory of the
manufacturer
". Respective transport expenses (out/back) are the
responsibility of the purchaser.
