ASSEMBLY OF THE LOG HORSE WITH CHAINSAW HOLDER
Fig 1. Pivot Clamp Support and
Measuring Rod -Insert the pivot clamp
support (adjustable vertically) into the
sawhorse table with the measuring
rod holder (adjustable horizontally)
using the bolt and washer supplied.
The vertical adjustment for the pivot
clamp support is to accommodate
different sized chain bars -the larger
and longer the bar, the higher the pivot
clamp should be placed.
Adjust so that the tip of the chain bar
extends beyond the table, so that it is
cutting completely through the log.
The measuring rod can be adjusted
horizontally to allow each log to be cut
to the desired length.
Fig 2. Pivot Clamp - Insert the male rod
on the pivot clamp into the female cylinder
on the pivot support clamp and secure
with the R clip.
Fig 3. Carefully lower the chainsaw bar
into position between the two solid blocks
in the pivot clamp and ensure a 2 cm gap
between the body of the chainsaw and the
clamp. Make sure that the bar is
approximately 90 degrees to the clamp and
well clear of the chain before tightening the
bolt. Once tightened, test the arc of travel
to make sure that the chain bar does not
touch any part of the sawbench.
