SKETCH OF OUTLINE
NOTICE ITEMS
Placement of welder
1. Please set it in less-vibration and flat place above 200mm away from
the wall.
2. Please put in clean and dry place less of iron-power, dust and paint.
3.Place it in the site avoiding rain or sea-water erosion.
Connection
1.Gound
a. There is ground terminal under the shell board. Please
ground with copper wire over 14mm.
b. Please arrange the expert or electrician to ground.
2. Power connection
Model
Sectional area of
output cable(mm )
2
Sectional area of
output cable(mm )
2
Air swicth current(A)
CT2228
CT2229
CT2230
60
60
75
Each welder need be equipped with a distributor box with switch and
over-current protection device. Please lead the power from the distributor
box to input terminal of welder by cable . The capacity of distributor box
and corss -sectional area of cable refer to below table.
? The above c ab le h as c op pe r c o il .
3
10
2
1
9
8
7
6
3
5
1
2
2
1
4
11
1. Wheel 2. Base bracket 3. Wind vent 4. Torch tie-in
5. Workpiece tie-in 6. Hand wheel 7. Temperature indicator
8. Power indicator 9. Power switch 10. Handle lever
11. Power contorl screw
≥
4
≥
6
≥
10
≥
25
≥
35
≥
50
2
3
4