11
12
22
23
24
25
26
27
28
29
30
Bottom stand
Case
Handle of switch
Switch
Power
Over-heat indicator
Metric cable gland
Screw cap of output
Adjust shaft
Insulation gasket
M10 screw
M8x10 screw
Hand wheel
Lid of hand wheel
Transformer supporter
U-type clamp
Current needle
Supporter of current adjustor
Transformer suportor
Main transformer
Thermometer
1fan
2metric cable glands
3lead of plug
4handle
5external-hexagon bolt
6shield
7m5x10 self-tapping screw
8m5x10 self-tapping screw
9screw
10screw
11gasket
12gasket
13round crossing screw
14external-hexagon bolt
15round crossing screw
16axle
17wedge
18wheel
19wedge
20flat crossing screw
21mark of grounding
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
31
32
33
34
35
36
37
38
39
40
41
42
When servicing, use only identical replacement parts. Use of any other parts may create
a HAZARD or cause damage to your welding machine.
Any attempt to repair or replace electrical parts on this power tool may create a hazard
unless repair is performed by a qualified technician.
PARTS LIST
ELECTRICAL INFORMATION
Warning
The cordless drill drivers come with a charger unit, this charger unit has a
moulded plug with a 5amp fuse. The plug is to BS 1363(A)
The fuse holder is in the center of the plug between the three pins. To
remove and replace fuse, get a small screwdriver and place at one end and
prize it up, it can then be removed and replaced. Always use a 5amp fuse.
Do not use any other rated fuses.
Machines that are connected direct to mains supply
.
For machines that are double insulated, do not require a connection to
earth.
If in doubt consult a qualified electrician
The wires are coloured as follows
Blue
Neutral (N)
Brown
Live (L)
Some machines come with an earth wire this is as follows
Green/Yellow Earth (E) 5amp BS 1363A
Fuse
Always secure the wires in the plug terminals carefully make sure no loose
strands are left exposed as they can short circuit and cause injury, fire and
or damaged the tool.
Secure the cable in the cord grip firmly.
Never use a light socket. Never connect the live (L) or neutral (N) wires to
the earth pin marked (E)
NOTE:
If your mains wires differ from the above consult a qualified
electrician. Always make sure the mains supply is of correct voltage and
you use the correct fuse protection
Regularly inspect all machines electrical connection and wiring condition
for damage. Any faults detected should be immediately rectified before
further use of the machine. Always have the wiring checked by a qualified
electrician
