Neilsen CT1406, Original Instructions Manual

Page: 7 / 16

6
SPECIFICATIONS
Max. operating pressure: 6.0 bar
Max. speed: 8500/min
Avg. air consumption: 4 cfm
Hose size: 3/ 8"
Air inlet: 1/ 4"
Steel cutting capacity: up to 16 gauge
COMPONENTS AND CONTROLS
INITIAL SETUP & ASSEMBLY
Air Supply
WARNING:
To prevent serious injury from explosion, use only clean, dry, regulated,
compressed air to power this tool. Do not use oxygen, carbon dioxide, combustible gases,
or any other bottled gas as a power source for this tool.
1. Incorporate a filter, regulator with pressure gauge, oiler, in-line shutoff valve, and quick
coupler for best service. Refer to the diagram at the end of this manual for more
information. An in-line shut-off ball valve is an important safety device because it controls the
air supply even if the air hose is ruptured. The shut-off valve should be
a ball valve because it can be closed quickly.
Note: if an automatic oiler system is not used, add a few drops of pneumatic tool oil to the
airline connection before operation. Add a few more drops after each hour of continual use.