![background image](http://html1.mh-extra.com/html/neilsen/ct0584/ct0584_original-instruction_3881543015.webp)
15
To move belt clip, remove the screw that holds the belt clip in place then
reassemble on the opposite side. Be sure to securely tighten screw.
INSTALLING BITS
Before fitting any drill bits set the forward/reverse button to the centre
position.
Open or close the chuck jaws to a point where the opening is slightly larger
than the bit size you intend to use.
Insert the drill bit straight into the chuck jaws. Do not insert the drill bit into the
chuck jaws at an angle. This could cause the drill bit to be thrown from the drill,
resulting in possible serious personal injury or damage to the drill.
Tighten the chuck jaws on the drill bit.
DRILLING
Check the direction of the forward/reverse button for the correct setting.
Secure the material to be drilled in a vise or with clamps to keep it from
turning as the drill bit rotates.
Hold the drill firmly and place the bit at the point to be drilled.
Depress the switch trigger to start the drill.
Move the drill bit into the workpiece, applying only enough pressure to keep
the bit cutting. Do not force the drill or apply side pressure to elongate a hole.
Let the tool do the work.
Depress the switch trigger to start the drill.
Move the drill bit into the workpiece, applying only enough pressure to keep
the bit cutting. Do not force the drill or apply side pressure to elongate a hole.