NEFF T5 L6E Series, Instruction Manual

Page: 35 / 52

Cookware check
en
35
t
Cookware check
Cookware check
This function can be used to check the speed and
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
1.
With the cookware still cold, fill it with approx.
200 ml of water and place it on the centre of the
hotplate with the diameter that most closely matches
that of the base of the cookware.
2.
Go to the basic settings and select the
™‚ ƒ
setting.
3.
Turn the twist knob.
b
flashes on the hotplate
displays.
The function is activated.
After 10 seconds, information on the quality and speed
of the cooking process appears in the hotplate displays.
Check the result using the following table:
To reactivate the function, turn the twist knob.
Notes
■
The flexible cooking zone only counts as a single
hotplate; place no more than one item of cookware
on it.
■
If the diameter of the hotplate used is much smaller
than the diameter of the cookware, only the middle
of the cookware can be expected to heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
■
You can find information on this function in the
section on
~
"Basic settings" .
■
You can find information on the type, size and
positioning of the cookware in the sections on
~
"Induction cooking" and
~
"Flex Zone" .
h
Power manager
Power manager
You can use the power manager to set the total power
of the hob.
The hob is preset at the factory. Its maximum
performance is specified on the rating plate. You can
use the power manager to change the value in
accordance with the requirements for the relevant
electrical installation.
In order not to exceed this set value, the hob
automatically distributes the power available between
the cooking zones that are switched on.
As long as the power manager function is activated, the
output of a cooking zone may temporarily fall below the
nominal value. If a cooking zone is switched on and the
power limit is reached,
¬
appears in the heat setting
display for a short time. The appliance automatically
regulates and selects the highest possible power level.
For more information about how the total power of the
hob is changed, see section
~
"Basic settings"
Result
‹
The cookware is not suitable for the hotplate and will therefore
not heat up.*
‚
The cookware is taking longer to heat up than expected and the
cooking process is not going as well as it should.*
ƒ
The cookware is heating up correctly and the cooking process
is going well.
* If there is a smaller hotplate available, test the cookware again on the
smaller hotplate.