24
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
ã=
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1.
Push the hook-in rack upwards at the front and unhook to the
side (figure A).
2.
Pull the hook-in rack forwards at the rear and unhook to the
side (figure B).
3.
Clean the hook-in rack with washing-up liquid and a sponge
or brush.
4.
Align the hook-in rack with the indentation (a) facing
downwards, so that the shelf heights match.
5.
Insert the hook-in rack at the rear as far as it will go and push
to the rear (figure C).
6.
Insert the hook-in rack at the front as far as it will go and push
downwards (figure D).
Faults and repairs
It is not always necessary to call the after-sales service.
Sometimes, you can find a remedy yourself. You will find some
tips for troubleshooting in the following table.
ã=
Risk of electric shock!
■
Work on the appliance electronics may only be performed by
a specialist.
■
Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
$
%
D
D
&
'
Problem
Possible cause
Remedial action
Electrical operation is faulty (e.g. indicator
lamps do not light up)
Fuse defective
Check fuses in the fuse box and replace if
necessary
Liquid or thin dough runs to one side
Appliance not installed level
Check the appliance installation (see
the Installation instructions)
Appliance no longer works,
‹
:
‹‹
flashes in
the clock display
There was a power cut
Reset the clock (see
section: Electronic clock)
‹
:
‹‹
flashes on the clock display,
“rrr” appears on the temperature display
The power supply was interrupted while
the appliance was in operation
Press the
KJ
clock function button.
Reset the clock (see
section: Electronic clock)
“E011” appears in the temperature display Permanent assignment of a button
Cancel the permanent assignment of the
button and press the
KJ
clock function
button
The temperature display shows, "EXXX",
e.g. E300
Internal fault in the appliance electronics
Press the
KJ
clock function button. If the
message does not go out, pull out the
mains plug and plug it back in again after
approx. 10 seconds
Appliance operation is not possible,
D
and -
†
- appear in the temperature display
The appliance has been locked
Deactivate the lock
(see section: Childproof lock)
Appliance operation is not possible,
D
and -
†˜
appear in the temperature display
The appliance controls were locked
permanently
Deactivate the permanent lock
(see section: Childproof lock)
The appliance does not heat up, the two
dots flash on the clock display
‚‡‹©
appears in the temperature display, for
example
A button combination was actuated
Switch off the appliance, press and hold
the
±
info button for 3 seconds, then press
and hold the
KJ
clock function button for
4 seconds, then press and hold the
±
info
button for 3 seconds
Electronically controlled functions are
malfunctioning
Energy surges (e.g. lightning strike)
Reset the function concerned
When an operating mode is switched on,
•
or
œ
appears in the temperature
display
The appliance has not cooled down fully
Wait until the appliance has cooled down,
then switch on the operating mode again
The appliance has switched off
automatically,
‹‹‹
flashes in the
temperature display
The appliance has switched off to protect
itself from overheating
Turn the operating mode selector back to
the
Û
position
