Page 19 of 24
LAN Settings
In the LAN Settings you find the settings to set the LAN parameter for the unit. Remember that
if you want the unit to use the current settings at next power up, you have to send the save
command.
Below are the settings for the LAN port. For all commands the mandatory start sequence look like
this: NEUNIT=<A>,SETTINGS=LAN.
Where <A> as default is 1. All commands must be started with a “,” and all lines must end with
a \CR
Description:
Syntax
<A>
Default <A>
R/W
Set unit IP address
IPADDRESS=<A>
xxx.xxx.xxx.xxx 192.168.254.252 R/W
Set unit sub net
SUBNET=<A>
xxx.xxx.xxx.xxx 255.255.255.0
R/W
Set gateway
GATEWAY=<A>
xxx.xxx.xxx.xxx 192.168.254.252 R/W
Select if DHCP is used or
not.
DHCP=<A>
ON, OFF
OFF
R/W
LAN speed (F = Full duplex-
,H = Half duplex)
SPEED=<A>
10F, 10H,
100F, 100H,
AUTO
100F
R/W
Set control TCP Port
IPPORT=<A>
0-65555
5000
R/W
Get the MAC address of
the unit.
MACADDRESS=<A>
xx:xx:xx:xx:xx
R
Set the multicast
address the unit must
use when communicating
with other Neets units
by LAN. (Remember when
changing this value, it
must also be done on all
other system this unit
must communicate with.)
After changing the
multicast address
remember to send the
save command in order
to make sure that the
system uses this
address at next reboot.
MULTICASTADDRESS=<A> xxx.xxx.xxx.xxx 224.10.10.25
R/W
Set the multicast port
the unit must use when
communicating with
other Neets units by
LAN. (Remember when
changing this, it must
also be done in all other
systems this unit must
communicate with.)
After changing the multi-
cast port, remember to
send the save command in
order to make sure that
the system uses this port
MULTICASTPORT=<A>
0-65555
7979
R/W