Page 9 of 15
Relay Control and Indication
The four test buttons are used to test the built-in relay
function. The test buttons are intended for use during
installation to control functionality of connected devices.
The LEDs will indicate if the relay is activated (green) or not
activated (off) during use of the test buttons. They will also
illuminate when the relays are controlled by the project
in the TanGo.
Be aware that you can activate multiple relays at the same time and damage
connected equipment if not carefull.
PoE Output Status Indication
The “poe” LED will show current status of the PoE output.
On
Valid PoE device connected to PoE output
Flashing slow
No PoE enabled device connected
Flashing fast
Error or overload on connected PoE device
IR Learner Input
The IR learner can be connected directly to the Neets Device Editor software
through the USB port. This enables learning of IR codes from your existing IR
remote for easy configuration on-site or at your desk.
Power and Error Indication
The “on” LED will show the current status of the unit.
Green
Neets Control - TanGo is on and running normally
Blue
Neets Control - TanGo is starting
Flashing red
The Neets Control - TanGo is in error mode, see section
“Error indication” on page 15 for details
310-0305-002-004 REV1 (Silkscreen Top plate)
designed in Denmark
Neets Control - TanGo
on
control
config
2
1
tx
rx
4
3
5
in / out
1 2 3 4
in
out
5 6 7 8
relay
on
ir
1
2
3
4
poe
310-0305-002-004 REV1 (Silkscreen Top plate)
designed in Denmark
Neets Control - TanGo
on
control
config
2
1
tx
rx
4
3
5
in / out
1 2 3 4
in
out
5 6 7 8
relay
on
ir
1
2
3
4
poe
310-0305-002-004 REV1 (Silkscreen Top plate)
designed in Denmark
Neets Control - TanGo
on
control
config
2
1
tx
rx
4
3
5
in / out
1 2 3 4
in
out
5 6 7 8
relay
on
ir
1
2
3
4
poe
310-0305-002-004 REV1 (Silkscreen Top plate)
designed in Denmark
Neets Control - TanGo
on
control
config
2
1
tx
rx
4
3
5
in / out
1 2 3 4
in
out
5 6 7 8
relay
on
ir
1
2
3
4
poe