Page 5
Doc. no#: 310-0050-001-002 R103 Manual
Technical description
Technical details:
RS-232
Baud: 1200-115200
Data bit:7/8
Parity: none, even, odd
Stop bit: 1/1,5/2
IR
Transmit 381 Hz – 500 KHz
LAN
10/100 MBit
Input
Sence low < 1 VDC
Sence high > 4 VDC
Output
Open drain
Max voltage: 24 VDC
Max current: 0,5 A
Power
110-230 V
Power out
12 VDC Max 0.35 Amp
Relay load max AC1
1150 Watt
Relay load max AC15 (230 VAC)
500 Watt
Relay single-phase motor rating (230 VAC)
370 Watt
Relay max voltage
230 VAC
Maximum screen size (recommended)
2,5 meters
USB
The USB port can only be used to program the Neets Control – ZULU from the Neets
Project designer software. It cannot be used to control any devices what so ever.
From the USB you can also power the system (except 12VDV/350mA out and the
onboard relays, those two things will not work). This is to be used in programming
situations, so you do not have to connect 110/230 volt to the unit to program it, BUT
for long periods of testing (testing your program) it is recommended to connect
110/230 to the unit, since the USB power is not made for long time powering of the
unit (more that 15-20 minutes at the time).
The USB connector needed to connect to the Neets Control – Zulu is of the type mini
USB B 5P. You can buy this cable on the web (buy a USB A to Mini USB B 5P).
The cable type is also widely used for MID device and compact cameras and so on.
Power output
The power output is used to power any external device that might need 12VDC (up to
350mA).
There is a small LED next to the connecter that indicate when there is power on the
connector
Time Battery (RTC)
The time keeping battery is of the type CR1216. The lifetime of the battery is
around 5-7 years.
To obtain a new battery, contact your distributor or search the web for CR1216.
Slide out the old battery (while power is disconnected) and slide in the new
battery. To reset the clock, you will need to upload the project for your system
again.
Summary of Contents for Zulu
Page 1: ......
