24
NED
XCM4085DLMT4
UME-0058-03
This camera uses 6-pin round shape push-pull lock type connector for the Power Supply
1
2
3
5
6
4
Figure 3-3-4 Power Supply Connector (HIROSE: HR10G-7R-6PB)
Table 3-3-2 Pin Assignment of Power Supply Connector
No
Name
1
12 –15V
2
12 –15V
3
12 –15V
4
GND
5
GND
6
GND
3.4 Power Supply
The camera requires a single power supply (DC+12 to +15V).
The indicator (LED green) blinks when supplying power, and it will change into
lighting in about five seconds.
Notes:
1) When selecting a power source, choose one with the capacity to allow for inrush
current. (10W or more recommended)
2) Insert the cable plug securely until it locks into position. This is to prevent the
connector from coming loose during power transmission.
3) Turn off the power supply at once when the indicator (LED green) doesn’t light
even if supplied power. Make sure that the power supply is used on proper
voltage and capacity and wiring arrangement is correct.
4)
It is recommended that the shield processing of the power cable is connected
with GND on the power supply side.
Acceptable Cable (Acceptable plug): DHPSH-10 (HIROSE: HR10A-7P –6S)
Power supply voltage: DC+12 –15V (+/-5%)
Consumption Current (rated): DC+12V: 350mA
If the lamp fails to illuminate even after power is supplied, turn off power immediately.
Inspect wiring. Check the voltage and capacity of the supplied power source.
