NED
SUi7450T2
UME-0033-01
20
To avoid uncoupling of cable connectors during power on, make sure to clamp them with
locking screws.
Do not unplug the cable while power is being supplied to the camera.
The pin assignment of the power supply connector is shown below.
Figure 3-3-4 Power Supply Connector (HIROSE: HR10G -7R- 6PB)
Round shape push-pull lock type
Table 3-3-2 Pin Assignment of Power Supply Connector
3.4 Power Supply
The camera requires a single power supply (DC + 12 to 15 V).
When selecting a power source, choose one with the capacity to allow for inrush
current. (15W or more recommended)
Insert the cable plug securely until it locks into position. This is to prevent the
connector from coming loose during power transmission.
Compatible Cable (Compatible plug): DGPSH -10 (HIROSE: HR10A -7P - 6S)
Power supply voltage:
DC+12 to 15 V (+/-5%)
Consumption Current (rated):
DC+12V: 440mA
The LED lamp illuminates when +12 V power is being supplied to the camera.
If the lamp fails to illuminate even after power is supplied, turn OFF power immediately.
Inspect wiring. Check the voltage and capacity of the supplied power source.
No
NAME
1
12 V
2
12 V
3
12 V
4
GND
5
GND
6
GND
HRS
6
5
2
1
4
3
