Baffle plate
Support rods
Brick retainer
1)
Remove the box of bricks from inside the heater.
2)
Ensure that the 6mm steel baffle plate is orientated
inside the firebox so that the 75mm fold is at the front
and directed upwards. Raise the front of the baffle plate
up until it clears the two support rods at the front. Slide
the baffle forward until the rear edge has cleared the
two support rods at the back. Raise the rear of the
baffle and slide back so that it is supported in a
horizontal orientation and pushed all the way back in
the firebox.
3)
Lift up the steel angle brick retainer and fit the bricks
standing on end around the sides and back of the
heater. There may be some gaps left between the
bricks, but this is not an issue since they will fill up with
ash as the heater is used. Refer to the diagram below for
brick configuration.
Legs Model:
Pedestal Model:
Top view:
6. TECHNICAL DRAWINGS
5. INSTALLING BAFFLE PLATE & FIRE BRICKS
