13
Remote Control Guide
Customizing the memory and preset buttons
You can store new head and foot positions by customizing the memory and preset buttons. For safety reasons, the Flat and
Anti-Snore buttons cannot be customized.
Move the head and/or foot sections to your desired position.
Press and hold the
FLAT
button and
the preset button
that you
want to customize for 5 seconds .
The new bed position is now stored in your selected preset button
overriding the factory default.
1
2
Pairing the remote control to your adjustable bed
Your adjustable bed is already paired to your remote at the factory. Manual pairing is only needed for replacement remote
controls.
Make sure your bed is connected to a working electrical outlet. A
surge protector is recommended.
To pair your remote control to your adjustable bed, do one of the
following:
•
Unplug the power cord from the outlet and then plug it
back in. The LED light on the control box turns blue and the
control box is in remote pairing mode for 20 seconds.
•
On the control box, press the
PAIR
button twice. The LED
light on the control box turns blue and the control box is in
remote pairing mode for 20 seconds.
On your remote control, press and hold the
HEAD UP
and
FOOT
UP
buttons at the same time for four (4) seconds.
If the pairing is successful, the LED light on the control box turns
to green immediately. If pairing fails, the LED light on the control
box stays blue and turns green only after the 20-second timeout.
Repeat steps 2 to 3 until pairing is successful.
1
2
3
Pairing method 1:
Unplug the power cord, then plug it back in.
Pairing method 2:
Press the PAIR button twice.
