NW Global Vending – TECHNICAL MANUAL
This document was produced by MARK AC for the exclusive use of the technical personnel in the after-sales service.
. No part of this document may be divulged to a third party or reproduced partially or entirely without the prior permission of NW GLOBAL VENDING
. All rights reserved.
New dispenser “KORO”
07/10/2005
page 11 / 42
5 - ELECTRICAL SAFETY AND RELEVANT STANDARDS
The vending machine
New Dispenser
was designed and made in conformity with the
provisions of the following directives and related European standards:
MACHINE SAFETY DIRECTIVE EEC 98/37
EN 60529 UNI EN 292 –1-2 IEC 695-2-2
LOW VOLTAGE DIRECTIVE EEC 73/23; EEC 89/392; EEC
89/336
(the low voltage directive covers all equipment powered with voltage below 400 V AC)
The following European standards are applied:
EN 60335-2-14 EN 60335-2-15 EN 60335-2-24 EN 60335-2-75
ELECTROMAGNETIC COMPATIBILITY DIRECTIVE
EN 61000-3-3 EN 61000-4-2 EN 61000-4-3 EN 61000-4-4 EN 61000-4-5 EN 61000-4-11
---…----…---…---
With regard to
Low Voltage
and
Electromagnetic Compatibility
this vending machine was tested and
certified by a certifying body authorised by ministerial decree:
IMQ
.
It is therefore prohibited (on pain of voiding the warranty and the responsibility of the certification) to
replace any electrical component with non-original parts during the routine and extraordinary maintenance
operations.
Therefore it is also prohibited to:
Tamper with or deactivate the safety systems installed in the vending machine.
Install the vending machine outdoor or in any case in a place that is not protected from the weather.
Use the vending machine for purposes other than those indicated in the sales contract.
Connect the vending machine by means of extension cords or multiple sockets and/or adapters.
Use water jets for cleaning.
Then, it is also compulsory to:
Verify the conformity and suitability of power supply line and of the power outlet.
6 – REQUIREMENT FOR THE USERS
For safety purposes, three different operators with different qualifications have been defined.
USER
The user is practically the final user who buys the products from the machine.
The user must not have any access whatsoever to the inside of the machine.
PERSON RESPONSIBLE FOR REFILLING AND ROUTINE CLEANING
The person responsible for refilling has the key for opening the machine and is in charge of the refilling,
cleaning and internal hygiene of the machine.
He must not have any access to energised parts or moving parts.
MAINTENANCE TECHNICIAN
The maintenance technician must be a highly skilled person and must be aware of the electrical hazards in
the event of complex technical operations and can operate with the machine switched on and the door
open, using the safety key supplied.
