122
Installation Manual, Chapter 5 – Installing Dterm Series i Optional Equipment
A6-506000-642-01(8508), Release 6.0, November 2003
3. Install the ferrite core (provided with the unit) about two 50mm
from the line cord plug.
4. Connect the line cord to the unit, limiting the cable length from the
AP(A)-R( )/AP(R)-R( ) Unit to the Single Line Telephone to a
maximum of 15 meters.
Note:
If only installing the AP(R)-R( ) Unit, plug the AC Adapter (ACA-U( )
Unit) power cord into the indicated AP(R)-R( ) Unit receptacle and
connect it to a power source. (Refer to
Adapter to an Installed Adapter on page 1-112
5. Replace the base plate (or wall mount unit) and reattach the line
cord. (Refer to
Section 9: Connecting a Dterm Series i Multiline Terminal on
.)
Figure 5-17:
Attaching the AP(A)-R( )/AP(R)-R( ) Units to the Multiline Terminal
Figure 5-18:
Installing the Ferrite Core on the AP(A)-R( )/AP(R)-R( ) Units
AP(A)-R( ) Unit
or
AP(R)-R( ) Unit