Setup and Operation 2-27
5.
Continue to the next field, Set User Password, to enter a user password. Enter the
password twice.
A dialog box notifies you that changes have been saved. Press
Enter
to continue. The
“User Password is” field changes to Enabled.
6.
In the final field on the screen, enable the password on boot to prevent unauthorized
access to the system. The user must then enter the User Password to gain access to
the system.
Remove a previously set password as follows.
1.
Enter Setup using the previously set password.
2.
In the Security menu, highlight Set Supervisor Password and press
Enter
.
3.
In each password field, press
Enter
. The dialog box stating that changes were saved
appears. Press
Enter
again.
The password is no longer enabled.
If you forget your password, proceed as follows.
1.
With system power on, carefully tilt the system on its side. Using a straightened
paper clip or other pointed object, press in the Password Override Switch on the
bottom of the system.
Figure 2-11 Password Override Switch
2.
Reboot and enter Setup. You may receive a Checksum error message.
3.
Go to the Exit screen and select Get Default Values.
4.
Press
Enter
. A dialog box informs you that the default values have been loaded.
