5-4 Solving Problems
NOTE
When the NEC Versa 2200C detects an error
related to display devices, it cannot display on either
the LCD or a CRT. The system warns you with a
beep.
POST Error Messages
The NEC Versa 2200C has a built-in checking program
that automatically tests its components when you turn the
system power on. This diagnostic test is called the Power-
On Self-Test (POST). If the system finds a problem during the
POST, the system displays an error message. If this hap-
pens, follow the instructions in the POST error message
table.
POST Error Messages
MESSAGE
WHAT TO DO
Diskette drive A
failure
Drive A
does not work or the diskette is not properly
inserted. Drive A is the diskette drive.
Press
F1
to start Auto Setup to check the diskette
drive parameters.
If there’s still a problem, drive A might need repair.
Diskette read failure –
press
F1
to run Auto
Setup. Press any other
key to retry boot
Remove the diskette from drive A and press
F1
to
enter Auto Setup to confirm that the diskette drive is
configured properly or press any other key to start
the system from the hard disk.
Or, insert a bootable disk in drive A and press any
key to start the system from the diskette.
Non-system disk or
disk error; replace
and press any key
when ready
Remove the diskette from drive A and press any
key to start the system from the hard disk.
Or, insert a bootable diskette in drive A and press
any key.
Summary of Contents for VERSA 2200C
Page 8: ...vi Contents ...