NEC SV8500, Manual

Page: 2929 / 3438

VOL.3-442
CHAPTER 4 CONFIGURATION SETUP
1.4.7 How to Set ToS Data
To set the ToS (Type of Service) data, follow the procedure below.
Note:
ToS values, except the one that is sent to DRS, are set from PCPro (at the system side).
Consequently, ToS value setting from the terminal is not especially required while the system is in opera-
tion.
1. DRS
2. Protims
Up Down Exit
STEP 2: Open the Administrator Menu by pressing "Hold"+"#"+"0" on the User Menu.
STEP 3: Select "8. Type of Service" by pressing "8" key on the Administrator Menu.
STEP 4: The display changes as follows. Choose one of the items from the menu.
Up
Down
1. DRS
2. Protims
3. RTP Self
4. Voice Control
Type of Service Menu List
1. Dterm IP Mode
2. Download Address
Up Down
Exit
[Administrator Menu]
7. Factory Value
8. Type of Service
Up Down
Exit
1. DHCP Mode
2. DRS Address Primary
Up Down Save Cancel
[User Menu]
Two items are displayed
on the IP Enabled Dterm.
The following Administrator Menu is displayed.
A
STEP 1: Open the User Menu by pressing "Hold" + "Transfer" + "*" + "#" on the terminal while
indicating time, an error message, or "DHCP Connecting.../DRS(1st) Connecting...".
1. DRS
2. Protims
3. RTP
4. Voice Control
: Press "1" key to change the ToS value that is sent to DRS.
: Press "2" key to change the ToS value that is sent to Protims.
: Press "3" key to change the ToS value that is sent to RTP.
: Press "4" key to change the ToS value that is sent to Voice Control.
Note:
When using Backup DRS, "DRS(2nd) Connecting...", "DRS(3rd) Connecting...", or "DRS(4th) Connecting..."
will be displayed instead of "DRS(1st) Connecting...".