•
Press
FNC
•
Press
HOLD
•
Press
*
•
Press
#
If you wish to leave system programming, you can do so by pressing
SPKR
.
Once you have changed any settings, you need to press
MIC
to store them. You can
move around on the display by using your * and # keys. Use * to move left, use # to
move right.
2-01 : Tenant CO/PBX Line Accommodation
This Memory Block area is used to specify which tenants will have access to each
CO/PBX line.
•
Enter system programming mode
•
Press Line Key 2
•
Dial
0 1
•
Enter value for tenant (0-3)
•
Enter value for CO/PBX line (1-8)
•
Enter access value
o
0 - Deny
o
1 - Allow
•
Press
MIC
to store the data
•
Press
SPKR
to go back on line
Note: (*) indicates default value
1-01 : Hookflash Time Selection
This memory block is used to enter the instantaneous break time of a Hookflash signal
to be sent to a CO/PBX line when the
RECALL
key on a Proprietary telephone is
pressed and the Hookflash end time for Single Line Telephones.
•
Enter system programming Mode
•
Press Line Key 1
•
Dial
0 1
•
Enter value for CO/PBX line (field 1)
o
0 - 0.4sec delay (*)
o
1 - 0.6sec delay
o
2 - 1.0sec delay
o
3 - 1.5sec delay
•
Enter value for SLT
o
0 - 0.4sec delay
o
1 - 0.6sec delay
o
2 - 1.0sec delay(*)
o
3 - 1.5sec delay
•
Press
MIC
to store the data
•
Press
SPKR
to go back on line
15
