MPO Connector
Pull tab
Key
Key
Front view of the plug
Plug of MPO cable
QSFP Module
While holding a part in the circle in
the figure, insert the direction of
arrow, please insert until a click is
heard
While holding a part in the circle
in the figure, insert the direction
of arrow, insert until a click is
heard.
A
Lamp
QSFP Connector
Pull tab
QSFP Slot
Align the module
with the QSFP slot of
the board.
To check the vertical direction of the
module, Check the position of the port
number and the lamp. See the above figure.
Port ID ”A”
Grasp a part in the circle of the
MPO plug in the figure, pull in
the direction of the arrow.
Grasp the pull tab and pull to
release the latch, and then
remove the module.
1.
Remove the Dust Cover(QSFP) ,insert this product to the QSFP Slot of the
board .
2.
Remove the Dust Cover(MPO) ,insert the plug of an optical cable to MPO connector of this
module.
N8104-161
QSFP+ Module (40G-SR4)
User’s Guide
Contents
1
Read this guide carefully and Keep this for your future reference.
Precautions for Use
NEC Corporation
This product is classified as a CLASS 1 LASER PRODUCT.
•
Read carefully “Precautions for Use” in
the manual of the LAN board, and observe the
instructions to ensure proper and safe use of this product.
Installation
□QSFP+ Module
□Serial number label
□ Warranty
□ User’s guide
Removal
1.
Remove the cable, and then attach the dust cover (MPO).
2.
Remove the QSFP module from the board, attach the dust cover (QSFP).
Dust cover(QSFP)
Pull tab
Dust cover (MPO)
MPO connector
QSFP connector
Descriptions
•
This warranty Card is available only for using in Japan.
Specification
Product Name
QSFP+ Module(40G-SR4)
Product Code
N8104-161
Data Transfer Rate
40Gbps ( 4 x 10G )
Type of Connector
MPO-type receptacle (1x12)
Voltage/Current
3.3V/0.35A
Operating condition
Temperature(C) 0-70
Humidity (%) 5-85
RH
(no condensation)
Disposing of your used product
In the European Union
EU-wide legislation as implemented in each
Member State requires that used electrical
and electronic products carrying the mark
(left) must be disposed of separately from
normal household waste. This includes
workstation or electrical accessories. When
you dispose of such products, please follow
the guidance of your local authority or ask
the shop where you purchased the product,
or if applicable, follow applicable legislation
or agreement you may have. The mark on
electrical and electronic products only
applies to the current European Union
Member States.
Outside the European Union
If you wish to dispose of used electrical and
electronic products outside the European Union,
please contact your local authority and ask for the
correct method of disposal.
EU Contact:
NEC Nederland
B.V.Olympia 4, 1213 NT Hilversum
The Netherlands
IMPORTANT:
-
This product is supported only for the servers
and options that is available for mounting
this product.
-
Keep the
"Serial Number Label".
-
Keep the removed “Dust Covers” for future
use.
This guide is made from recycled paper
1st. Edition
October 2016
7-1 Shiba 5-Chome, Minato-Ku
Tokyo 108-8001, Japan
Trademark, name and address of the manufacturer:
Finisar Corporation
1389 Moffett Park Drive, Sunnyvale, CA 94089,USA
