NEC PX2000UL, User Manual, Page: 107 / 111

88
7. Appendix
POWER STATUS LIGHT TEMP. Projector status
Preparing for powering ON
Blue
(Blink*
4
)
Off Off Off
POWER STATUS LIGHT TEMP. Projector status Procedure
A button has been pressed
while the [CONTROL PANEL
LOCK] is activated. The [CONTROL PANEL
LOCK] is activated. The
setting must be canceled to
operate the projector. (
→
page 67 )
Blue
(Light)
Orange
(Light)
Status varies Off
ID numbers for the projector
and the remote control do not
match. Check the control IDs (
→
page 65 )
Temperature problem (In the
“Forced ECO MODE”) Ambient temteprature is high.
Lower the room temperature.
Blue
(Light)
Off Orange
(Light)
Orange
(Light)
*1 Repetition to light on for 1.5 seconds / off for 7.5 seconds
*2 Repetition to light on for 2.5 seconds / off for 0.5 seconds
*3 Repetition to light on for 0.5 seconds / off for 0.5 seconds / on for 0.5 seconds / off for 2.5 seconds
*4 Repetition to light on for 0.5 seconds / off for 0.5 seconds
Indicator Message (Error message)
POWER STATUS LIGHT TEMP. Projector status Procedure
Temperature problem Ambient temperature is out of the
operation temperature. Check if any
obstruction stays near the exhaust
vent.
Red
(Blink*
4
)
Off Off Off
Lens mounting error/Lens problem Lens is not mounted properly. Mout it.
If the indicator message is remain un-
changed even if the lens is mounted
properly, contact your dealer.
Red
(Blink*
4
)
Red
(Light)
Red
(Light)
Off
Error requiring service support Contact your dealer or service person-
nel. Make sure to check and inform
indicator status for asking to repair.
Red
(Light)
Status
varies
Status
varies
Off
*4 Repetition to light on for 0.5 seconds / off for 0.5 seconds
• When the thermal protector is activated:
When inside temperature of the projector becomes too high or low, the POWER indicator start to red blink in a short cycle. After
this happened, the thermal protector will activate and the projector may be turned off.
In this case, please take the below measures:
- Pull out the power plug from the wall inlet.
- Place the projector in cool place if it has been placed in high ambient temperature.
- Clean the exhaust vent if dust has accumulated on.
- Leave the projector for about one hour until inside temperature gets lower.