Setting System Board Jumpers 5-7
CLEARING YOUR PASSWORD
If you forgot your password, use the following procedure to
clear your current password and to set a new one.
1.
Power off and unplug the system and any peripherals.
!
WARNING
The system power must be off before removing the
cover and changing a jumper setting.
2.
Remove the system unit cover (see the Option
Installation Center in your online documentation ).
3.
Locate the Password Clear jumper pins on the system
board (see the figure “Locating system configuration
jumpers” earlier in this chapter).
You may have to remove any installed expansion boards
to access the jumpers (see the Option Installation Center
in your online documentation).
4.
Set a jumper on the Password Clear jumper pins.
5.
Replace the system unit cover (see the Option
Installation Center in your online documentation).
6.
Connect system power cables and monitor.
7.
Power on the system. The system lets you boot your
computer.
8.
Power off, unplug the system and monitor, and remove
the cover.
9.
Remove the jumper block from the Password Clear
jumper pins.
Summary of Contents for POWERMATE
Page 115: ...Index 5 ...