NEC POWERMATE CT 815 - RELEASE NOTES, Service And Reference Manual

Page: 74 / 155

3-22 Disassembly and Reassembly
Removing the Two-Device Bracket
A – Two-Device Bracket B – Bracket Tab
5.
Remove the three or four screws fastening the device to the bracket and slide the device out
of the bracket.
6.
If installing a new device in the bay, see “Installing a 3 1/2-Inch Accessible Device” next.
7.
If the bay is to remain empty, install the bay cover and bracket front cover as follows.
!
Press the bay cover into the empty slot in the bracket front cover.
!
Position the bracket front cover in front of the bracket, align the posts and tabs with
their respective openings, and press in the cover until it locks in place.
8.
Slide the bracket into the empty bottom 5 1/4-inch accessible bay until the bracket locks in
place.
9.
Connect signal and power cables to any installed devices.
10.
Replace the front panel and the cover.
Installing a 3 1/2-Inch Accessible Device
Before installing a 3 1/2-inch accessible storage device in the system, follow any preinstallation
instructions that come with the device. For 3 1/2-inch accessible IDE devices (for example, a
Zip drive), cable correctly as the first (master) or second (slave) device on the primary or
secondary IDE channel (see the table “IDE Cable Configurations” earlier in this section for
sample configurations).
The cables used for installing 3 1/2-inch accessible storage devices include:
!
two-connector signal cable for the diskette drive
!
three-connector IDE signal cable for a Zip drive
!
system power cables in various lengths come from the power supply to accommodate a
variety of supported storage configurations.