35
8. TOOLS
8-3. DATE AND TIME
Set the current date and time in this device.
Item
Description
Remarks
Time zone settings
Set the time difference with UTC (Universal Time, Coordi-
nated) and the region where this device is used.
The default value is “+00:00”.
Example: When using the
device in Japan, set it to
“+09:00”.
Date and time set-
tings
Set the current date and time. Synchronize with the NTP
server on the network and put a check mark in “Internet
Time Server” to obtain the correct time. Then enter the IP
address or host name of the NTP server to perform updat-
ing.
The default date is
“01/01/2015” (Thu). The de-
fault time is “00:00”.
Summer time set-
ting
Set summer time. When Enable is checked, summer time
is enabled. Set the various time differences and the start
and end of summer time.
Important:
• When using the clock function of this device, leave the device in the standby mode if it is not going to be used.
If the projector leaves for over two weeks without the power supply, the set date and time will be reset to the factory default setting
and the clock function will become ineffective. When the clock function becomes ineffective, set "Date and time" again.
NOTE:
• If date and time is reset around the timing of starting or finishing Summer time, Summer time setting may not become effective
properly.
In case date and time is required to reset, perform the settings in order of TIME ZONE
→
DATE AND TIME SETTING
→
SUMMER
TIME.
8-4. ADMINISTRATOR MODE
Select the menu mode of this device, enable/disable the saving of settings of the entire projector, and configure thep-
assword setting in the administrator mode.
Item
Description
Remarks
Menu mode
Select the basic menu or advanced menu. See the user's
manual of the projector for the items that can be used in the
respective menus.
Do not save the set-
tings
Put a check mark if you are not saving the value of the con-
figured item in the on-screen menu.
No check mark as the factory
default setting.
New password / Con-
firm new password
Set the password in the administrator mode.
A maximum of 10 alphanumeric
characters.
8-5. DEFAULT APP
Omit to display the application menu and select the start-up function either when the APPS button on the remote
control is pressed, or [APPS] is selected as the input terminal on the onscreen menu.
Item
Description
Remarks
Default application
When the projector is turned on under the condition of being
selected the "APPS" terminal, select function either the APPS
MENU or the viewer.
The default factory setting is
“APPS MENU”.
