background image

 

5880 Sheridan Boulevard, Arvada, Colorado 80003 

Ph: 303-412-0399  

  Fax: 303-412-9346   

www.displaydevices.com 

 

 

 

 

Pole Mount 

 

1.

 

Install a 1 ½” NPT pipe with male threads on lower end from the ceiling.  Aftermarket 

mounting pans and accessories are available. 

2.

 

Thread locking ring onto pipe.  Thread mount (pn 72-046) onto pipe and leave locking 

ring loose. 

3.

 

Attach interface plate (pn 72-1073) to projector with (5) M4 x 10 pan head Phillips 

screws, lock and flat washers.   

4.

 

Align interface plate into holes on mount, slide stand off bolts into slot and tighten.  Add 

center locking Torx cap screw which attach secures the interface plate to the mount. 

5.

 

Attach the wire safety rope to the interface plate with the enclosed coupler. 

6.

 

Insert power and signal cables through pipe and out the top of the mount head to the 

projector and attach to projector. 

7.

 

Adjust left-to-right yaw.  When desired position is attained, tighten locking ring on pipe 

to mount. 

8.

 

Loosen tilt adjustment cap screw with enclosed tool and level the projected image to the 

screen.  Tighten cap screw when a level image is achieved. 

9.

 

Loosen up-down pitch adjustment cap screw with enclosed tool and adjust the pitch 

angle of the projector.  Tighten cap screw when at desired projection position. 

10.

 

If desired, add Kensington lock through the opening of the mount head, loop through 

cable end and attach to projector.  

 

 

Reviews: