NEC NEAX IPS NWA-008869-001, Installation Manual

Page: 27 / 180

CHAPTER 2 INSTALLATION
– 17 –
NWA-008869-001 Rev.1.0
atch2001.fm
REQUIRED EQUIPMENT
This table shows the equipment required when providing the In-Skin Router.
Required Equipment for In-Skin Router
*: Prepared by customers
EQUIPMENT DESCRIPTION QUANTITY REMARKS
PN-RTA (RTA) In-Skin Router Card 1-8 Maximum 8/PIM
PZ-M649 (DTI) T1 Digital Trunk Interface (1.5
Mbps) Card 1-8 Mounted on PN-RTA Card
NOTE
PZ-M650 (DTI) E1 Digital Trunk Interface (2
Mbps) Card 1-8 Mounted on PN-RTA Card
NOTE
PZ-M623 (ETHER) Ether Control (10BASE-T)
Card 1-8 Mounted on PN-RTA Card
PC* Local Console 1
MAT CA-P
or
MAT CA-R
or
MAT CA-T
MAT cable with 25 pin D-SUB
connector (4 m [158 inch])
MAT cable with 25 pin D-SUB
connector (2 m [79 inch])
MAT cable with 9 pin D-SUB
connector (2 m [79 inch]) 1 Cable between the In-Skin
Router and local console.
HUB* As required
• 10BASE-T cable
(TIA/EIA category3 or
larger)*
• 100BASE-TX cable
(TIA/EIA category5)*
10BASE-T/100BASE-TX
cable As required Cable between PN-RTA/PZ-
M623 and IP network
Cable length:
Maximum 100 m (328 ft.)
T1 Network cable* Twisted pair cable with RJ-48C
connector As required Cable between PZ-M649 and
Digital Private Line (T1)
Cable length:
Maximum 200 m (655 ft.)
for DSX-1
Maximum 1758 m (5764 ft.)
for DS-1
E1 Network cable* Twisted pair cable with RJ-48C
connector As required Cable between PZ-M650 and
Digital Private Line (E1)
Cable length:
Maximum 400 m (1310 ft.)
REQUIRED EQUIPMENT