NEC NC900C, Installation Manual, Page: 52 / 104

52
Projector Adjustment and Connecting
3-5. Setting the Projector Projection Method
The projection method can be changed in the projector menu. In the factory default settings, it is set to front (installed on a
stand and projecting from the front of the screen).
NOTE
When installed on the ceiling, always set “Fan Tilt Setting” (page 73) correctly.
1
Press the MENU button for three seconds or longer.
The Passcode input screen appears on the LCD screen at the projector’s control panel.
Press the EXIT button to return to the original screen.
2
Enter the passcode and press the ENTER button.
If you make a mistake during input, you can move the cursor by pressing the LEFT/RIGHT buttons and overwrite the
passcode.
If the passcode is correct, you can use the service personnel menu.
3
Press the LEFT/RIGHT button to display “Configuration” and press the DOWN button.
4
Press the LEFT/RIGHT button to display “Installation” and press the DOWN button.
5
Press the LEFT/RIGHT button to display “Orientation” and press the DOWN button.
6
Check that “Image Orient” is properly selected and press the DOWN button.
If “Image Orient” is not properly selected, press the LEFT/RIGHT buttons to select it.
7
Press the LEFT/RIGHT buttons to select the projection method.
When shipped from the factory, it is set to [Normal-F].
Normal-F Front projection. With the projector installed on the pedestal, projection is executed
from the front of the screen.
Normal-R Rear projection. With the projector installed on the pedestal, projection is executed
from the back of the screen.
UpsideDown-F Ceiling front projection. With the projector installed on the ceiling, projection is
executed from the front of the screen.
UpsideDown-R Ceiling rear projection. With the projector installed on the ceiling, projection is
executed from the back of the screen.
8
Press the ENTER button.
An (*) will be put on the selected projection method.
9
Press the EXIT button.
Returns to the “Orientation” screen. Next, set the installation method.
10
Press the LEFT/RIGHT button to display “Fan Tilt Setting” and press the DOWN button.
11
Press the LEFT/RIGHT buttons to select the projection method.
When shipped from the factory, it is set to [Floor].
Floor Select when the projector is installed on a desktop.
Ceiling Select when the projector is installed on the ceiling.
12
Press the ENTER button.
An (*) will be put on the selected fan operating mode.