27
2. Installation and Connection
Attaching the power cable stopper
To prevent the power cable from accidently removing from the AC IN of the projector, attach the supplied power cable stopper to
clamp the power cable.
CAUTION
• To prevent the power cable from coming loose, make sure that all the prongs of the power cable are fully inserted into the AC
IN terminal of the projector before using the power cable stopper to fix the power cable. A loose contact of the power cable
may cause a fire or electric shock.
• Do not bundle the power cable. Doing this could cause heat or a fire.
NOTE
• Do not clamp the power cable with other cables. Doing so can generate noise, which can affect adversely the signal
cable.
• Be careful not to insert the band inversely. Once the band is attached, it cannot be removed from the slot.
1
Set the clamper band to the power cable side, and insert the end of band of the power cable
stopper into the slot next to the AC IN on the terminal panel.
Attach the power cable stopper to the other side in the same way.
2
Pass each band through the slits in the power cable stopper.
Pass the bands through them so that the power cable will be sandwiched from above and below.
band
