18 Built-In AIT Auto-Loader Unit
Ejecting the magazine
To eject the magazine from the Built-In
AIT Auto-Loader Unit, press the EJECT
button.
A message “Magazine Ejecting” appears
in the LCD. The AIT data cartridge set
in the read/write drive is returned to the
magazine. Then, the magazine is
automatically ejected from the Built-In
AIT Auto-Loader Unit. Hold the
magazine firmly and remove it from the
Built-In AIT Auto-Loader Unit.
Check
✔
• It may take about 2 minutes until the magazine is ejected from the Built-In AIT Auto-Loader Unit
after pressing the EJECT button.
• The Built-In AIT Auto-Loader Unit does not do anything by pressing the EJECT button while the
BUSY lamp is blinking.
Reading/writing data
To read/write the data from/to the AIT cartridge and compress the data to be written, refer to the
instruction manual provided with the backup software.
LCD
The LCD on the front of the Built-In AIT Auto-Loader Unit allows you to check the status of the
driver and AIT data cartridges. (As shown below, you can change the LCD display orientation
along with the Built-In AIT Auto-Loader Unit installation orientation. For details, refer to P. 24.)
Horizontal display
Vertical display
➀
➆
➅
➁
➂
➃
➄
➅
➁
➀
➆
➃
➄
➂
Summary of Contents for N8551-29F
Page 46: ......
