NEC N8190-7153, User Manual

Page: 42 / 46

5. Troubleshooting
5-1. Troubleshooting
•
Error message is displayed at boot
Refer to the user's guide of Computer for details of error messages.
If you feel the PCI slot where this product is attached is the cause of the error, please check the
following items;
●
When Option ROM is not expanded,
→ Refer to the user's guide of Computer to disable the Option Rom whose function is not in use.
●
When the error occurred on the PCI slot where this product is attached,
- Please connect correctly this product again.

If the error message is displayed at boot even when all the above items are
confirmed, shut down the computer, connect the product to other PCI slot, reboot
the computer, and perform the self-diagnostic program POST. If POST ends
normally, the computer may be defective. Please contact your retailer or service
center for repair.
•
This product does not work properly.
If your operating system or applications do not operate correctly after installing this product, please
check the following items, and please refer to the “User's Guide” of the server.
●
Is the driver for the Fibre Channel Controller installed? Is the product installed in the computer
correctly?
- Please
re
fer to User's Guide attached to the server.
●
Are all Fibre Channel cables, SFP+ modules and power cords connected correctly?
- Please connect correctly this product again.
●
Is the WWPN address setting correct if you have connected this product to a Fibre Channel device
which uses WWPN address?
- Confirm WWPN address of this product, by referring to "Appendix Confirm WWPN addresses
after setup".

If the computer does not work correctly even when all the above items are
confirmed, shut down the computer, disconnect the product, reboot the computer,
and perform the self-diagnostic program POST. If POST ends normally, this
product may be defective. Please contact your retailer or service center for repair.
Notice
Notice
- 40 -