English-4
Quick Start
To attach the MultiSync LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2.
For the PC or MAC with DVI digital output:
Connect the DVI signal cable to the connector of the display card in your
system (
Figure A.1
). Tighten all screws.
For the PC with Analog output:
Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your
system (
Figure A.2
). Tighten all screws.
For the MAC:
Connect the Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to
the Macintosh cable adapter (
Figure B.1
). Tighten all screws.
NOTE:
Some Macintosh systems do not require a Macintosh cable adapter.
3. Remove the connector cover (
Figure C.1
).
4. Place hands on each side of the monitor to tilt the LCD panel 30 degrees angles (
Figure C.2
).
5. Connect all cables to the appropriate connectors through the square hole in the stand (
Figure C.3
).
Figure A.1
Figure B.1
Macintosh
Cable Adapter
(not included)
Figure A.2
DVI signal cable
Figure C.1
Figure C.2
Figure C.3
Summary of Contents for MultiSync 20WGX2 Series
