NEC M166C, Customer Engineer Manual

Page: 16 / 56

Setting up a Template
© NEC Nederland B.V. 2015 Page 16 M166 CE Manual
Auto Answer Settings:

Auto Answer Mode
Determine whether Auto Answer is required or net, and if so, select the number of
rings before the auto answer is activated.

Auto Answer Number
When receiving an incoming call from this particular number, the call will be
answered automatically after approximately one ring no matter how many rings have
been selected in the previous setting. Even when automatic answer is disabled in the
previous setting, still a call from the predefined extension will be automatically
answered.

Auto-Answer Internal
When enabled, internal calls will always be answered automatically, and calls from
external will ring and not be automatically answered.

Auto Answer Message
When enabled, the M166 will automatically answer a message that instructs to set
up a call automatically, using commands <<ANxxxx>> or <<AFxxxx>> in the
message. The M166 is instructed to setup a voice call to the number xxxx. The M166
gives first a short, low volume indication, unless the ringer is muted. Please note
that this functionally depends on conditions. The functionality and conditions are
explained in the IP DECT Advanced DATA Manual, section “
Conditional Special
Message Strings
” in chapter
Special Messages/Features to Handsets .

Silent Answer Message
When enabled, the M166 is instructed to setup a voice call to the number xxxx in a
command <<ASxxxx>> or <<ALxxxx>> in the message. The M166 does not give an
audible indication.
Please note that this functionally depends on conditions. The functionality and
conditions are explained in the IP DECT Advanced DATA Manual, section
“
Conditional Special Message Strings
” in chapter
Special Messages/Features to
Handsets .