NEC LE2200, User Manual, Page: 90 / 150

4-30
Upgrades and Options
Installing a 5.25-Inch Device
!
Caution: CD-ROM devices contain a laser system and
are classified as CLASS 1 LASER PRODUCTS. In case
of any trouble with a CD-ROM, please contact your
nearest service representative. To prevent direct
exposure to the laser beam, do not try to open the
enclosure.
Use of controls or adjustments or performance of
procedures other than those recommended by the
manufacturer may result in hazardous radiation
exposure
Note: Contact your sales representative or dealer for a
list of approved optional peripheral devices.
1. Power off the system and remove the side panel as
described earlier in this chapter.
2. Remove the front panel as described earlier in this
chapter.
Notice: Observe static precautions. Use an antistatic
wrist strap.
3. Remove the device from its protective wrapper and
place it on an antistatic surface. Record the drive
model and serial number in the equipment log.
4. Set any drive jumpers or switches before you install
the drive. See the documentation that comes with the
device for jumper or switch information.
Notice: When using SCSI optional devices, the SCSI
termination resistors must be installed in the last SCSI
device of the daisy chain cabling. All other devices must
have terminators removed.
Notice: When using an IDE optional device, the device
jumper must be set as the slave device.