possibile to be compliant with the spec. But we still have to check with the
general test pattern
to make sure every secondary is compliant with the specification.
6.12 All Modes Reset
After final QC step, we have to erase all saved changes again and restore the factory
defaults. You should do All Mode Reset
(Refer to Chapter 3)
again.
7 Cleaning
Please use non-alcohol cleanser to clean LCD panel and cosmetics
material with soft cotton.
8 Inspection Standard
Y
Appearance Inspection: Scratches/Abrasions
a.) Mechanical:
Face A:
Not Acceptance
Figure 1: Face A View
Summary of Contents for LCD1511M
