Figure 4.3
Position A
Position B
6.2)
Finish
6.1)
Install screws and put screw labels back on.
(Number of screws that hold BEZEL is 12 pieces.
Number of labels is 12 pieces.)
Figure 4.4
Figure 5.1
Figure 5.2
Figure 6.1
Figure 6.3
Figure 6.2
Figure 5.3
Figure 5.4
Figure 4.2
4.2)
Paste 11 pieces of BRACKET-4 to panel.
NOTE: 1. Adjust the position of BRACKET-4 to the upper hole
in case of POSITION A.
2. Adjust the position of BRACKET-4 to the lower hole in case
of POSITION B.
Figure 4.1
4.1)
Paste TAPE-2 (DOUBLE sided ADHESIVE TAPE) on
BRACKET-4 and peel off the paper.
(Number of BRACKET-4 is 11 pieces.) Specification of
TAPE-2 should be equivalent to "3M VHB tape 9473".
NOTE: Do not paste TAPE-2 on the holes.
Adjust the position of BRACKET
PWB IR to the upper hole.
Adjust the position of
BRACKET-4 to the lower hole.
Align edge
Original
Protection glass
10 mm
5 mm
5.1)
Paste TAPE-3. Specification of TAPE-3 should be equivalent
to "Scotchfoam 4718 3,2 / 12,7mm". Ideal Size: 5mm (H) X 10mm
(W) (Fig. 5.2)
NOTE: Align the edges of the panel and the glass
(refer to Fig.5.1). 2.Carefully move the BRACKET PWB IR as in
Fig. 5.3, when pasting TAPE-3.
Paste TAPE-2 on this area
BRACKET-4
TAPE-2
A
A
A
A
A
A
B
A
A
A
A
Peel paper off after pasting TAPE-2
TAPE-3
