NEC EXPRESS5800/120Ld, Service Manual

Page: 84 / 194

4-12 Dissasembly and Reassembly
10. Position the processor back into the retention module. Ensure that
the alignment notch on the bottom of the cartridge fits into the
connector key in the slot. Push down firmly, with even pressure
on both sides of the top, until clicking noises are heard as the
cartridge is seated.
11. Replace the left side panel, the front door, plug in the system
power cord, and power up the system.
DIMMs
The system board contains four DIMM sockets labeled 1 through 4 (Figure 4-9).
Each socket can hold a single 72-bit DIMM module with 64MB, 128MB,
256MB, 512MB, or 1GB of memory. When all four sockets are populated, the
system board supports a maximum of 4 GB of memory with 1GB DIMMs. A
DIMM will always be installed in socket 1. When you install additional
DIMMs, you must start with the first empty socket next to the DIMMs already
installed. When you remove DIMMs, you must start with the highest number
occupied DIMM socket on the system board.
Figure 4-9. DIMM Locations