NEC EXPRESS5800/120Ld, Service Manual

Page: 104 / 194

4-32 Dissasembly and Reassembly
Installing or Swapping a Hard Disk Drive
1. Power off the system and ensure it is disconnected from the AC power
source.
2. Open and remove the front door.
3. Remove the left and right side panel as described earlier in this chapter.
4. Tag and disconnect all interface cables and voltage cables connected to all
drives in the drive bay.
Note:
The drive bay is secured to the system chassis
with five screws: one screw is located on the left side of the
drive bay, two screws are located at the front of the drive
bay, and two additional screws are located at the right side
of the drive bay.
5. Remove the two mounting screws securing the drive bay to the right side of
the chassis. See Figure 4-28, A, and B.
A
B
C
D
E
Figure 4-28. Removing the Hard Disk Drive Bay