NEC ELECTRA ELITE IPK II, Installation And Maintenance Manual

Page: 13 / 56

Hardware, Installation and Maintenance Manual 1 - 1
___________________________________________________________________________________
___________________________________________________________________________________
Chapter 1
Electra Elite IPK II IAD(8)-U( ) ETU
S
ECTION
1 D
ESCRIPTION
The IAD(8)-U( ) ETU is an optional interface package for Electra Elite IPK II KTS that
can combine trunk and tie line calls into H.323 trunks. This ETU can be assigned as
a 2-port TLI(2)-U10, 4-port DID (4)-U10, 4-port or 8-port DTI-U10 ETU, COI/
COID(4)-U10, or 8-port COI/COID(8)-U10.
The onboard 10/100 base T-connector provides WAN/LAN connectivity. The NEC
IAD ETU contains a regular TCP/RTP/IP stack that can handle real time media,
supports industry standard H.323 communication on the WAN side, and interfaces
with the Electra Elite IPK II as a regular interface board. The IAD card, from the
network administration perspective, is an end-point on the IP network. For the KSU
system technician, it is just like any other trunk interface (depending on the operating
mode described in
Chapter 4 IPK II IAD(8)-U( ) Configuration ).
This interface can provide:
K
DTMF detection
K
DTMF generation
K
Real-Time Transfer Protocol (RTP) port number designation )
K
Type of Service (TOS) field Quality of Service (QOS) support
K
Tone generation
K
General Tone detection
K
G.711, G.723 and G.729a voice compression
K
10/100 BASE-T LAN interface
K
Caller ID detection (when in COID mode/DTI/ANI)
K
Remote configuration and maintenance
K
H.323 Gatekeeper support
K
H.323 V1/V2 signaling protocol