Chapter 1 : Aspire Conference Bridge PCB
PCB Description
Aspire Conference Bridge Manual
◆
3
LED Indicators
Table 1: 16CNFU PCB LED Indications
PCB Buttons
The 16CNFU PCB has the following buttons.
●
PCB Reset Button SW1
To perform a hard reset (reset the PCB to factory defaults), pull the PCB from the system cabinet, hold
the SW1 button in, reinsert the PCB, and continue holding the button for approximately 5 seconds. Wait
approximately 90 seconds for the PCB to
Þ
nish resetting.
●
Reset Button SW3
This switch allows the technician to reset the 16CNFU PCB. Pressing the Reset button while the PCB
is installed and operating will perform a soft reset of the PCB (resets the PCB, but retains the current
settings).
LED Description
On
Off
DS1
Channel Status (Back of PCB)
Not Currently Used
Not Currently Used
DS2
Channel Status (Back of PCB)
Not Currently Used
Not Currently Used
DS3
Channel Status (Back of PCB)
Not Currently Used
Not Currently Used
DS4
Channel Status (Back of PCB)
Not Currently Used
Not Currently Used
DS5
Channel Status (Back of PCB)
Not Currently Used
Not Currently Used
DS6
Channel Status (Back of PCB)
Not Currently Used
Not Currently Used
DS7
Channel Status (Back of PCB)
Not Currently Used
Not Currently Used
DS8
Channel Status (Back of PCB)
When any Conference
circuit in use
Off when no Conference
circuits in use
DS9 LIVE
PCB
Active PCB
Inactive
DS10
CF BUSY
Flash Access
No Flash Access
LED 3 (DS13)
Conference Status
(Back of PCB)
Conference Initialized
Conference Not Initialized
LED 2 (DS12)
Insertion Status (Back of PCB)
Insertion Complete
Insertion Not Complete
LED 1 (DS11)
Boot Status (Back of PCB)
Boot Complete
Boot Incomplete
