English-7
English
To avoid falling down
Fasten the LCD monitor to wall or pillar with a cord or chain
which is sufficient to support the weight of the LCD monitor
(approx. 16kg).
Before moving the LCD monitor, the cord or chain should be
removed.
You can attach mounting accessories to the LCD monitor in
one of the following two ways:
In the upright position
Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding
objects as shown in the diagram to the right.
How to Mount and Attach Options to the LCD Monitor
Lay the screen face down
Lay the protective sheet on a table, which was wrapped
around the monitor when it was packaged, beneath the
screen surface so as not to scratch the screen face.
This device cannot be used or installed without the Tabletop
Stand or other mounting accessory. Failure to follow correct
mounting procedures could result in damage to the
equipment or injury to the user or installer. Product warranty
does not cover damage caused by improper installation.
Failure to follow these recommendations could result in
voiding your warranty.
When using with other mounting accessory, it must be a
VESA-compatible mounting method and the screws must be
M4 of size and 8mm or longer of length under consideration
of the thickness of the mounting method. (Recommended
torque: 150 ~ 170N cm)
Protective Sheet
Tabletop Stand
hole of fix
Clamper
Cord or Chain
(not supplied)
100mm
100mm
100mm
100mm
100mm
Ambient temperature should be less than 40°C.
* Use some fans as needed.
*
*
01_English
15/10/02, 12:07 pm
7
Summary of Contents for AccuSync LCD3000
