English−13
English
Setup
For box contents, please refer to the printed contents sheet provided in the box.
The accessories included depends on the location where the monitor was shipped.
To attach the base stand to the monitor stand:
Align the locking tabs on the base stand with the holes on the monitor stand. Insert
the base stand into the monitor stand. Make sure the locking tabs engage, and that
the base is securely attached to the monitor before continuing these instructions and
using the monitor (Figure 1).
NOTE::
Handle with care when attaching the stand.
To connect the monitor to your system, follow these instructions:
NOTE::
“Important Information” on page 3
before installation.
1. Turn off the power to your computer.
2. Connect devices to the monitor.
CAUTION: •
Use the provided specified cables with this product so as not to interfere with radio and television
reception.
For mini D-Sub 15-pin, please use a shielded signal cable with core.
For DisplayPort, HDMI, and AUDIO, please use a shielded signal cable.
Use of other cables and adapters may cause interference with radio and television reception.
•
Do not connect headphones to the monitor while you are wearing them. Depending on the volume
level, it may damage your ears and cause loss of hearing.
NOTE: •
Adjustment of the volume control as well as the equalizer to other settings than the center position may
increase the ear-/headphones output voltage and therefore the sound pressure level.
•
Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor lowers the sound.
•
Incorrect cable connections may result in irregular operation, damage display quality/components of the LCD
module and/or shorten the module’s life.
Figure 1
Base Stand
Monitor Stand
Power cord
D-SUB
DisplayPort
HDMI
Audio IN
Headphone
