5
•
Turn the screws 4 x ST4*25 mm as far as these
stick out about 10 mm from the wall.
•
Hang up the hood. Check the secure fitting, the
horizontal position and tighten first the upper and
then the lower screws through the hood body.
•
Remove the protective foil from the ducts.
•
Put on the outer (lower) duct and fix
it laterally to the hood with the
screws 2 x ST4*8.
For the extraction mode:
For the extraction mode:
For the extraction mode:
For the extraction mode:
•
Attach a flexible extraction hose (not
supplied) with an inner diameter of
Ø120 mm onto the connecting piece.
•
Slide the inner (upper) duct along the
slide fixture into the outer (lower)
duct. Make sure that the inner duct is
aligned with the vents at the top.
•
Determine the extension length of the duct cover
by pulling up the inner duct or sliding back into the
outer duct.
•
Attach the mounting rail at the upper duct ending.
Drill mounting holes 2 x Ø8 mm and insert the
dowel pins. Use the screws 2 x ST4*25 mm to se-
cure the rail.
For the extraction mode:
For the extraction mode:
For the extraction mode:
For the extraction mode:
•
Check the correct position of the flexible extrac-
tion hose and connect it with the extraction out-
let to the outside.
•
Pull the inner duct upwards and fasten the duct
cover laterally to the previously
mounted rail using the screws 2 x
ST4*10 mm.
Installing the activated carbon
Installing the activated carbon
Installing the activated carbon
Installing the activated carbon filter for recirculation
filter for recirculation
filter for recirculation
filter for recirculation
mode
mode
mode
mode
•
Remove the aluminum grease filter.
•
Place the carbon filter onto the air intake of the
extraction duct. Make sure that the mounting pins
on the extraction duct engage the mounting slots
of the carbon filter. Turn the filter clockwise until it
clicks into place.
•
Reinstall the aluminum grease filter.
Electrical connection
Electrical connection
Electrical connection
Electrical connection
WARNING:
WARNING:
WARNING:
WARNING:
•
The installation to the mains supply must conform
to the local standards and regulations.
•
Improper connection may cause to an electric
electric
electric
electric
shock
shock
shock
shock!
•
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
•
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
•
Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
•
Connect the mains cable to a properly installed
and earthed wall outlet.
•
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Startup / Operation
Startup / Operation
Startup / Operation
Startup / Operation
Cooker hood
Cooker hood
Cooker hood
Cooker hood
The diameter of the pot and pan floors should be
according to the size of the cooking zone.
