4
Installation
Installation
Installation
Installation
There must be a safety distance between the hot-
plate of the cooking pot on the hob and the bottom
part of the cooker hood:
The distance must be between 60
The distance must be between 60
The distance must be between 60
The distance must be between 60 –––– 75 cm. For gas
75 cm. For gas
75 cm. For gas
75 cm. For gas
appliances, the distance must be at least 65 cm.
appliances, the distance must be at least 65 cm.
appliances, the distance must be at least 65 cm.
appliances, the distance must be at least 65 cm. If
the installation instructions for the gas cooker specify
a greater distance, this distance must be taken into
consideration.
Selecting the fume outlet
Selecting the fume outlet
Selecting the fume outlet
Selecting the fume outlet
You can operate the cooker hood in two modes:
Extraction mode
Extraction mode
Extraction mode
Extraction mode
WARNING:
WARNING:
WARNING:
WARNING:
•
The extracted air may not be vented into a flue
which is used for the waste gas from appliances
which are powered by gas or other fuels.
•
When venting the extracted air, comply with the
regulations of the relevant local authorities.
The hood has an upper air outlet to vent cooking
odours to the outside.
The extracted air is normally vented
vertically. The extracted air can vented
through the wall units and the loft floor
to the roof ridge.
If there is a conduit under the wall units,
the extraction duct can be routed so that
the extracted air can be vented horizon-
tally through the wall.
•
Before mounting, check that the wall has sufficient
load capacity to bear the cooker hood.
•
When drilling the holes in the wall always make
sure that no existing electrical cables or other ob-
jects are damaged.
•
Make sure that the ventilation slots are clear of
obstacles and are not covered.
NOTE
NOTE
NOTE
NOTE:::: Recomm
Recomm
Recomm
Recommendations for preparation work
endations for preparation work
endations for preparation work
endations for preparation work
•
When installing, ask another person to assist.
•
Wear protective gloves to prevent injuries from
any sharp edges.
•
Determine the position of the cooker hood central-
ly above the hob in conformance with the speci-
fied safety distances.
•
Align the drilling template and mark the necessary
holes for the wall mounting. Check them with a
spirit level.
•
Drill mounting holes 4 x Ø8 mm and insert the
dowel pins.
