NDS DOMETIC SL12-100, Installation And Operating Manual

Page: 11 / 184

EN
CAUTION! Damage hazard
All cables of power connections must have a minimum cross-section of 25 mm², or in any case, the cross-
section must be matched to the required length of the cable.
5. Connect the starting battery positive , the inverter positive and the house battery positive cables .
fig.

on page 2
6. Install and tighten the three M6 nuts.
7. Loosen the two pin terminal screws.
CAUTION! Damage hazard
To prevent damage to the equipment, the house battery negative must be connected at the end of the in-
stallation.
8. Connect the D+ signal wire to pin and the house battery negative wire to pin .
fig.  on page 3
9. Tighten the two pin terminal screws.
Note If the device is connected correctly, it should emit an acoustic signal.
10. If the device does not emit an acoustic signal, press the On/Off switch.
fig.

on page 3
11. Install the lid and secure it with the two screws.
12. If the vehicle is equipped with a smart alternator (Euro-6), bridge connectors and with the supplied jumper
cable.
fig.

on page 4
Note Connecting the jumper cable to either of the two connectors activates the smart alternator
mode.
9 Air conditioner connection (Optional)
To establish a connection between the device and an air conditioner, the wiring of the supplied 3-pin connector is
necessary. The wiring configuration of the connector depends on the air conditioner model. The management of an
air conditioner requires only two of the three pins of the connector to be used.
fig.

on page 4
Normally open
Common
Normally closed
The following table shows which pins should be used depending on the air conditioner model.
Air conditioner Pin configuration
Dometic CA1000, CA2500
-
Dometic B2200, B2600
-
Dometic FreshJet -
10