NCR 7169, Owner'S Manual

Page: 156 / 244

6-136 Reflashing the Printer Firmware
/HID Only for K8 printers.
/NHPI Only for 7199 printers.
/PRTR Only for 7199 printers.
[parameter]––> Selections for interface parameter (Only for RS232 and
Ethernet interface):
For RS232 Only: Please key in the Baud Rate, Parity and Stop Bit
– Baud Rate Selection:
/[115200] | [57600] | [38400] | [19200] | [9600]
– Parity Selection:
/[none] | [even] | [odd]
– Stop Bit Selection:
/[1] | [2]
For WiFi / Ethernet Only: Please key in the IP Address
– IP Address Selection:
/[xxx.xxx.xxx.xxx] – xxx is a number from 0 to 255
For CPMI, IBMUSB and HID is ignore
[file] ––> Selections for the filename:
Any valid binary file with extension *.mfw | *.sfn |
*.dfn | *.ipl | *.lan | *.bin (Only for K8) | *.tbl (Only for SSCO6–
1ST/2ST and 7199) | *.cfg (Only for 7199)
[print(opt)] ––> Selections for the print (Optional Parameter):
/print (default) Print printer configuration form.
/noprint Bypass printing printer configuration form.
[status(opt)] ––> Optional for Return Status (Optional Parameter):
/noretstat (default) Utility will not return status code.
/retstat Utility will return status code.
[ErrorTimeOut(opt)] ––> Failsafe: Max Time Allowed for Called Exe
(Optional Parameter):
/ErrorTimeOut=xxx (minimum=420) xxx is number of Seconds – limit
3600.
Information : Please use RS232 Interface, when switching from ION <=>
NON ION
The following error message is displayed when correct parameters are not used:
Error: Too few / many command line parameters!
The following is an example of a command line:
TseFlash.com /7197–5X01/6X01 /m /COM1 /115200 /none /1 SP2M0609.MFW
/noskip /print /retstat
This command displays the GUI interface and a progress bar indicator shown in the
next section. The same GUI interface is displayed when the program is ran through the
GUI Windows GUI Printer Firmware Update Utility.